About
We design and manufacture 3D concrete printing systems in Ukraine
Our mission is rebuilding Ukraine through accessible 3D concrete printing. So we make equipment, software and training that let a team print on its own.
Seal of Excellence and EU support
DrukDim completed a Seeds of Bravery (UASEEDs) grant and holds the programme's Seal of Excellence. UASEEDs grant agreement No 101104445, European Innovation Council, Horizon Europe.
Funded by the European UnionFunded by the European Union. Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or European Commission. Neither the European Union nor the granting authority can be held responsible for them.
What we do
The full cycle — from equipment to training
Equipment
KuBrick and Brama printers, DrukMix feed, extruders.
Software
DrukOS controls the printer and feed; DrukSlice prepares toolpaths for concrete.
Commissioning and training
We install, tune the system to your mix and train your team to work on its own.
Research & Partnership
Joint research, grant consortia, custom development.
How we work
What you can expect from us
The task first
We do not sell a printer from a catalogue. We look at the task first, then select or design a system for it.
Honest about limits
We say where 3D concrete printing makes sense and where it does not. We do not promise what we cannot deliver.
Built for the task
We configure and adapt the equipment and software to the customer's task.
For the long term
After commissioning the team works on its own and calls us when it needs help.